<Apti
Code
/>
Back
Question 1283: Which of the following describes the basic operation of a single-slope A/D converter.
tcs
wipro
infosys
general
aptitude
interfacing-to-the-analog-world
No answer description is available.Let's discuss.
The input voltage is used to set the frequency of a voltage-controlled oscillator (VCO). The VCO quits changing frequency when the input voltage stabilizes. The frequency of the VCO, which is proportional to the analog input voltage, is measured and is displayed on the digital display as a voltage reading.
A ramp generator is used to enable a counter through a comparator. When the ramp voltage equals the input voltage the counter is latched and then reset. The counter reading is proportional to the input voltage since the ramp is changing at a constant V/second rate.
A ramp voltage and analog input voltage are applied to a comparator. As the input voltage causes the integrating capacitor to charge, it will at some point equal the ramp voltage. The ramp voltage is measured and displayed on the digital panel meter.
Any of the above could be correct, depending on the specific type of A/D converter involved.
Submit Answer
Show Answer
Previous
Next